eCtune BaseMap Creator - Parameters

Mapsensor: Select a predefined mapsenor or fill in the min and max mbar.
Note: If you want to know if you configuration is good. The KOEO mbar displayed shouldn't differ much from the PA(baro) mbar
Injector Setup: Select the injector size(this will adjust injector fuel trim and crank fuel trim) select the correct battery offset table
Boost Setup:
                  -Not Boosted(10 columns) NA cars
                  -Boosted:
                               -Boost columns: Select the amount of columns you want(max 14). Your mapscalars will be setup. You can change them later
                               -Boost cut: You can enable a boostcut during creation
                               -Boost fuel: Boost fuel sets how much additional fuel to add to the boost portion of the basemap. The more efficent the turbo is, the higher you want to set this number. A good starting point is usually 120%
                               -Boost retard: This will retard a specified amount timing per PSI(starting at the first boost column)
Base: This will show you whice codebase and version is in the basemap creator.
Setup these parameters and press "NEXT"

New BaseMap Creator -> Ecu Type

Here you need to select the ecu type you have.
This will set:
                 -ELD
                 -Baro sensor
                 -Knock sensor
                 -Injector test
                 -O2 heater
                 -VTEC enable/disable
                 -VTEC points
                 -Rev limit points(cold/hot)
After selecting the ecu type press "NEXT"

New BaseMap Creator -> Base map

Here you select which fuel and ignition map you will start with.
Ecu: Which ecu the map was orginally
Regoin: JDM/EDM/USDM/CDN
Engine: which engine the stock map was designed
Description: About the map
Note: You can select a map with extended high cam rpm scale(11000 rpm) 
         These are basemap. Tuning is always required.

After selecting the right ignition and fuel map press "Finish".