NOTE: This will adjust the map scalar for the selected map set(primary or secondary)

Increment:
Start psi:          The first boost value for the first column. Specify 0 here and the first column with get the increment.
Increase:          Amount of psi the load increments each column
Column:           The first boost column
Note:                You can specify 1 psi increment for the first 3psi(e.g. column 11,12,13) then 2 psi increments for the following 4 columns)

Devide:
Coloumn:          Fill in the first boost column
Start pressure:  The start psi for the first given column 
End pressure:    End psi for the last column
This will devide the boost range over the boost columns of your map

Rpm scalar setup

Note: This will adjust the currect rpm scale. E.g. if low cam primary map is selected this scalar will change

Increment:
Start rpm:           The rpm the first given row will get
Increase:             Amount of rpm the following row get increased
Starting row:        Which row you start adjusting
Note:                   You can make the first row increase e.g. 300 rpm and afterward 500 rpm

Devide:
Start rpm:           The start rpm of your rpm band
End rpm:            The end rpm of your rpm band
Starting row:        Start row
Note:                  The rpm band will be devide into row(start) till the last row.